MIL-DTL-3950J
SOCIETY OF AUTOMOTIVE ENGINEERS
-
Terminals, Lug: Splices, Conductor: Crimp Style, Copper, General
Specification for.
-
Wire, Electric, Polyvinyl Chloride Insulated, Copper or Copper Alloy.
(Copies of these documents are available from Society of Automotive Engineers, 400 Commonwealth
Drive, Warrendale, Pennsylvania, 15096-0001 or www.sae.org/)
UNDERWRITERS LABORATORIES, INC. (UL)
-
Tests for Flammability of Plastic Materials for Parts in Devices and Appliances.
(Copies of these documents are available online at www.ul.com/ or from the Underwriters Laboratories,
Inc., 333 Pfingsten Road, Northbrook, IL 60062-2002.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict
between the text of this document and the references cited herein (except for related specification
sheets), the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between the requirements
of this specification and the specification sheet, the latter shall govern.
3.2 Switch categories. Switches furnished under this specification shall be category I, category II, and
3.2.1 Category I switches. Category I switches are completely defined by a MS standard or
specification sheet (see 3.1).
3.2.2 Category II switches (see 6.2). Category II switches are the same as category I switches except
for minor differences such as termination configuration, operating characteristics, and minor actuator
variations, which do not change the basic design or construction of the qualified switch. Category II
switches shall be acquired from a source listed on the Qualified Products List (QPL) for the particular
similar product in category I. Category II switches are nonstandard.
3.2.3 Category III switches (see 6.2). Category III switches are not covered by MS standards or
specification sheets. These switches are nonstandard.
3.3 Qualification. Category I switches furnished under this specification shall be products which are
qualified for listing on the applicable QPL at the time set for opening of bids.
3.4 Material. Unless otherwise approved by the preparing activity material shall be as specified herein.
When a definite material is not specified, a suitable material shall be used which enables the switches to
conform to the performance requirements of this specification. Acceptance or approval of any constituent
material shall not be construed as a guaranty of the acceptance of the finished product.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business