MIL-DTL-24317B
1.2.1.3 Enclosure design. The enclosure design is identified by a single digit in accordance with
table II.
TABLE II. Enclosure design.
Symbol
Seal
1
Unsealed
2
Dripproof
3
Watertight
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification.
This section does not include documents cited in other sections of this specification or recommended for
additional information or as examples. While every effort has been made to ensure the completeness of
this list, document users are cautioned that they must meet all specified requirements of documents cited
in sections 3 and 4 of this specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those cited in the solicitation or contract.
FEDERAL
SPECIFICATIONS
-
Plastic, Polyamide (Nylon), Rigid: Rods, Tubes, Flats, Molded and Cast Parts.
STANDARDS
-
Screw-Thread Standards for Federal Services
COMMERCIAL ITEM DESCRIPTIONS (CIDS)
-
Rubber, Silicone
DEPARTMENT OF DEFENSE
SPECIFICATIONS
- Chemical Conversion Coatings on Aluminum and Aluminum Alloys.
- Anodic Coatings, For Aluminum and Aluminum Alloys.
MIL-DTL-6363/6 - Lamps, Incandescent, Aircraft Service Single Contact Submidget Flanged
Base T-1 Bulb
MIL-DTL-6363/8 - Lamps, Incandescent, Aircraft Service Single Contact Midget Flanged Base
T-1-3/4 Bulb
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business