INCH-POUND
MIL-PRF-8805/100G
6 December 2012
SUPERSEDING
MIL-PRF-8805/100F
4 October 2004
PERFORMANCE SPECIFICATION SHEET
SWITCHES, SENSITIVE, PLUNGER, 10 AMPERES 2PDT AND
7 AMPERES 4PDT, RESILIENT SEAL
This specification is approved for use by all Departments and Agencies of the Department of Defense.
The complete requirements for acquiring the switches described herein shall consist of this specification
and the latest issue of MIL-PRF-8805.
LOCKWASHER See note 6
NASM 35333-80
or EQUIVALENT
See note 6
NOTES:
1. Dimensions are in inches.
2. Unless otherwise specified, tolerances are ±.010 (.25 mm) for two place decimals and
±.005 (0.127 mm) for three place decimals.
3. Metric equivalents are given for general information only.
4. Contour optional provided maximum dimensions specified are not exceeded.
5. The marking (identification and circuit schematic) shall be permanently and legibly
marked on the switch case in the location shown (on side of body opposite keyway).
6. Hex nut shall be MS21340-05 or equivalent. Alternative base metals and protective
finishes, as approved by the qualifying activity, may be utilized for hardware material.
FIGURE 1. Pin plunger switch.
AMSC N/A
FSC 5930
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business