MIL-PRF-22885/18K
Inches
mm
Inches
mm
Inches
mm
.003
.08
.050
1.27
.375
9.53
.004
.10
.055
1.40
.42
10.7
.005
.13
.070
1.78
.446
11.33
.006
.15
.090
2.29
.447
11.35
.007
.18
.104
2.64
.468
11.89
.015
.38
.110
2.79
.470
11.94
.016
.41
.13
3.3
.615
15.62
.02
.5
.136
3.45
.650
16.51
.025
.64
.27
6.9
.719
18.26
.030
.76
.349
8.86
2.10
53.3
.048
1.22
.36
9.2
NOTES:
1. Dimensions are in inches.
2. Unless otherwise specified, tolerance is ±.016 (.41 mm) for three place decimals and ±.03 (8 mm) for
two place decimals.
3. Metric equivalents are given for general information only.
4. Alignment of lens index slot to mounting flat 90° ±2°. Applicable to units with snap-in lens.
5. One hole mounting is recommended when panel seal is utilized.
6. Terminals shall be permanently identified as shown.
FIGURE 2. Panel cutout, circuit diagram and nonturn washer - Continued.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business