MS75075D
TABLE I. Detail requirements.
MS part number |
Circuit with toggle lever in |
Current capacity (amperes) |
|||||
Keying side |
Center |
Opposite keying side |
28 V dc (seal level) |
28 V dc (70,000 ft) |
115 volts/60 Hz (Sea level) |
||
Inductive |
Resistive |
Inductive |
Resistive |
||||
-1 -2 -3 -4 |
Maintained 2-3 5-6 |
None |
Maintained 1-2 4-5 |
2.5 |
7 |
2.0 |
1.5 |
1. All switches on this standard are designed so that the movement of the switch mechanism is same as the toggle lever.
2. Maximum weight is .01 pound.
3. Black finish on bushing.
4. Non-nutrient fungus resistant case material in accordance with ASTM-D5948.
5. Strength of actuating lever pivot and lever stop test shall be performed at 8 pounds.
6. Dielectric strength after electrical endurance is 300 volts from terminal to ground.
7. Terminals will accept 18 AWG wire.
NOTES:
1. Referenced documents shall be of the issue in effect on the date of invitations to bid.
2. For design feature purposes, this standard takes precedence over acquisition documents referenced herein.
Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of changes.
Referenced Documents: MIL-DTL-83731
ASTM-D5948
Custodians: Preparing activity: Army - CR DLA - CC
Navy - EC
Air Force - 11 (Project 5930-1919-01)
NOTE: The activities listed above were interested in this document as of the date of the this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the Assist Online database at https://assist.daps.dla.mil.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business