MS21351G
Inches |
mm |
Inches |
mm |
Inches |
mm |
.002 .003 .005 .010 .012 .016 .024 .025 .030 |
0.05 0.08 0.13 0.25 0.30 0.41 0.61 0.64 0.76 |
.032 .045 .052 .072 .169 .240 .338 .351 |
0.81 1.14 1.32 1.83 4.29 6.10 8.59 8.92 |
.364 .432 .438 .469 .572 .687 .706 |
9.25 10.97 11.13 11.91 14.53 17.45 17.93 |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerances are ±.010 (0.25 mm) on decimals and ±5° on angles.
FIGURE 1. Dimensions and configuration - Continued.
REQUIREMENTS:
For hardware detail specifications, see appendix of MIL-DTL-8834.
In the event of a conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence.
Shock: Method I and method II (high impact). The switch shall be electrically and mechanically operative at the conclusion of the shock test except there can be mechanical transfer of the contact mechanism at all levels when tested in accordance with method II (high impact).
Toggle seal test: Method II.
Weight: .0429 pound maximum (19.4 grams).
Strength of terminals: 5 pounds pull perpendicular to mounting plane and 2 pounds in other planes. Dielectric withstanding voltage: 1,200 V rms at sea level.
Altitude: 50,000 feet.
115 V ac, 60 hertz electrical endurance tests are to performed at room temperature and pressure.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business