MIL-DTL-5423-12 Boot, Dust And Water Seal, Type A \(For Toggle Switches\), Style 9 \(Five-Hole Mounting, Through\)

Pages 1 - 2

MIL-DTL-5423/12D

REQUIREMENTS

Dimensions and configuration: See figure 1.

Silicon rubber: Grade 50.

Watertightness: 5 pounds-force per square inch gage.

Part or Identifying Number (PIN): M5423/12-A9.

Qualification: Not ApplicQualification: First Article Testing in accordance with MIL-DTL-5423.

The margins of this specification are marked with vertical lines to indicate where modifications were made. This was

done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these

notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire

content irrespective of the marginal notations.

Reference Documents

MIL-DTL-5423

Custodians:

Preparing activity:

Army - CR

DLA - CC

Navy - AS

Air Force - 85

(Project 5930-2008-068)

DLA - CC

Review activities:

Army � AR

Navy � MC, SH

Air Force � 99

NOTE: The activities listed above were interested in this document as of the date of this document. Since

organizations and responsibilities can change, you should verify the currency of the information above using the