INCH-POUND
MIL-DTL-24236/16G
4 October 2004
SUPERSEDING
MIL-S-24236/16F
28 June 1995
DETAIL SPECIFICATION SHEET
SWITCH, THERMOSTATIC (METALLIC), TYPE II, OVERHEAT
DETECTOR, ADJUSTABLE, DUAL TERMINAL, 3 AMPERES
Inactive for new design after 16 August 1999.
This specification is approved for use by all Depart-
ments and Agencies of the Department of Defense.
The complete requirements for acquiring the switches described herein
shall consist of this specification and the latest issue of MIL-PRF-24236.
NOTES:
1. Dimensions are in inches.
2. Unless otherwise specified tolerances are .016 (0.41 mm).
3. The shell and flange must be perpendicular within ± 1 degree.
4. The mounting bracket forms an integral part of the switch housing.
5. A locking feature shall be incorporated to prevent inadvertent changing of the adjusting screw. Both the
adjusting screw and the locking feature shall be protected with a metal cover, wired in place as shown, in such a
manner that removal of this protective cover is required to permit readjustment. Removal and replacement of
the cover shall not easily be accomplished without the use of some device considered a tool.
6. The adjustable feature is provided for maintenance to maintain marked set point within the setting tolerance of
table 1.
7. The temperature setting shall be marked on the seal cap.
FIGURE 1. Configuration and dimensions.
AMSC N/A
FSC 5930
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business