MIL-DTL-13735G
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
FEDERAL STANDARDS
-
Screw-Thread Standards for Federal Services Section 2 United Inch Screw
Threads-UN and UNR Thread Forms.
DEPARTMENT OF DEFENSE SPECIFICATIONS
-
Cables, Special Purpose, Electrical: Low-Tension, Heavy Duty Single-Conductor
and Multiconductor Shielded and Unshielded, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
-
Identification Marking of US Military Property.
-
Test Methods for Electronic and Electrical Component Parts.
-
Connector, Receptacle, Electrical-Pin Contact. No 12, 14 and 16 A.W.G.
Waterproof.
-
Switch. Toggle-SPST. SPDT 24 Volt dc, 25 Amp (Waterproof).
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or
https://assist.daps.dla.mil/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,
Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
-
Soldered Electrical and Electronic Assemblies, Requirements for s.
-
Calibration Laboratories and Measuring and Test Equipment, General
Requirements for.
(Copies of these documents are available online at https://dod.nssn.org/search.html or from the American National
Standards Institute (ANSI), 11 West 42nd Street, New York, NY 10036-8002, telephone 212-642-4900, fax 212-302-
1286.)
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
-
Standard Method of Salt Spray (Fog) Testing.
-
Standard Practice for Determining Resistance of Synthetic Polymeric Materials to
Fungi
(Copies of these documents are available online at https://www.astm.org or from the American Society for Testing
and Materials, 100 Barr Harbor Drive, West Conshohocken, Pennsylvania, 19428-2959.)
INTERNATIONAL ORGANIZATION FOR STANDARDS (IS0)
-
Quality Assurance Requirements for Measuring Equipment - Part 1; Metrological
Confirmation System for Measuring Equipment.
(Copies of these documents are available online at https://dod.nssn.org/search.html or from the American National
Standards Institute (ANSI), 11 West 42nd Street, New York, NY 10036-8002, telephone 212-642-4900, fax 212-302-
1286.)
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business