MS75063D
REQUIREMENTS
Type II (sufficiently high pressure closes contacts) grade A (waterproof) class 2 (low vibration) of procurement specification.
Switch contacts shall close from 40 to 110 PSI (actuating pressure) and remain closed upon increasing pressure.
Switch contact rating at 24 volts DC: resistive load 3 Amps.
Switch shall meet overload pressure requirements of procurement specification except applied pressure shall be 1800 PSI for 30 seconds. Switch shall not disintegrate under 2500 PSI
Marking: The switch shall include the following information, in the order shown: Military part number
Manufacturer's part number
Manufacturer's name
Referenced documents
MIL-DTL-12211
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where modifications from this revision were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations.
Custodians: Preparing activity
Army - AT DLA - CC Air Force - 85
DLA - CC (Project 5930-2012-038)
Review activities: Air Force - 99
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.dla.mil/ .
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business