MS25225J
TABLE I. Detail requirements.
Dash No. |
Type |
Panel Thickness (REF) |
Operating Force |
Remarks |
-1 |
1-Hole Mounting |
.050 to .248 |
1.0 to 2.5 LB |
|
-2 1/ |
3-Hole Mounting |
.050 to .081 |
Identical to -1, Except Keyway is Rotated 180° |
|
-3 |
1-Hole Mounting |
.050 to .248 |
Notes:
Material: Plastic molded red, color STD 11136, FED-STD-595.
Finish: Corrosion resistant, zinc plate ASTM B633, black enamel, lusterless, color 37038 or semigloss, color 27038, FED-STD-595 or equivalent.
Guard shall remain in either open or closed position.
Opening the guard shall not change the position of the switch contacts.
When lever is in upward position, closing guard shall throw lever to center position.
When lever is in downward position, closing guard shall not throw lever to center position.
Referenced Documents
MIL-DTL-7703
ASTM-B633
FED-STD-595
The margins of this specification are marked with vertical lines to indicate where modifications made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations.
Custodians: Preparing activity: Army - CR DLA - CC
Navy - AS
Air Force - 11 (Project 5930-2007-041) DLA - CC
Review activities: Air Force - 99
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil/.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business