INCH-POUND MS25100K
17 March 2004
SUPERSEDING MS25100J
26 June 1995
MILITARY SPECIFICATION SHEET SWITCH, TOGGLE, TWO POLE, SEALED TOGGLE This specification is approved for use by all Depart-
ments and Agencies of the Department of Defense.
The requirements for acquiring the switch described herein shall consist of this specification sheet and MIL-DTL-83731.
MS25100K, dated 17 March 2004, is hereby reactivated and may be used for either new or existing design acquisition.
Inches mm Inches mm Inches mm Inches mm Inches mm
NOTES:
.004 0.10
.012 0.30
.020 0.51
.03 0.8
.072 1.83
.094 2.39
.240 6.10
.432 10.97
.468 11.89
.47 11.9
.69 17.5
.719 18.26
.969 24.61
1.281 32.54
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified, tolerances are ±.020 (0.51 mm) on two place decimals and
±.005 (0.13 mm) on three place decimals.
4. For hardware detail specifications, see appendix of MIL-DTL-83731.
5. Dome on top of the mounting bushing is permissible, not to exceed .09 (2.3 mm).
FIGURE 1. Dimensions and configuration.
AMSC N/A FSC 5930
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business