MS24655 Switch, Toggle, Positive Break, Miniature Toggled Sealed, Single Pole, Solder Lug Or Integrated Wire Terminals: .250 Mounting Bushings

Pages 1 - 2 - 3 - 4 - 5

MS24655S

TABLE I. Detail requirements. 51

MS dash no.	Circuits made between terminals as indicated with the toggle lever in these positions: 11			Current capacity in amperes						Life low current level switching 5 mV
				Resistive load			Inductive load
				28 V dc	115 Volts		28 V dc	115 Volts
	Opposite locking tab side 41	Center position	Locking tab side 41		60 Hz ac	400 Hz ac		60 Hz ac	400 Hz ac
-211	2-3 ON	OFF	ON 1-2	5	2	3	21 1	1	2	31 25 µA
-221		NONE	OFF
-231		NONE	ON 1-2
-241		OFF	NONE
-271	MOM-ON 2-3		1-2 MOM-ON
-281	NONE
-311	ON 2-3
-321 61 71	NONE	ON

11 Direction of movement of internal mechanism is opposite to the direction of the toggle movement.

21 With time constant of .020 ± .002 seconds.

31 Contact resistance not to exceed 50 ohms during life, low current level switching.

41 Nonfunctional terminals shall not be supplied.

51 Part or Identifying Number (PIN) example: For IWTS termination MS number will be concluded by the letter W.

Example: MS24655-211 with IWTS termination will be MS24655-211W.

61 Dielectric withstanding voltage: 1,200 V rms at sea level (center on circuits).

71 Delayed action of the switch toggle lever may cause circuit to close or open before snap action mechanism trips.