MIL-PRF-22885/96D
Inches
mm
Inches
mm
.016
0.41
.700
17.78
.020
0.51
.750
19.05
.030
0.76
.770
19.56
.062
1.57
.875
22.22
.200
5.08
2.470
62.74
.250
6.35
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only and are based upon 1.00 inch = 25.4 mm.
3. Unless otherwise specified, tolerances are ± .010 (0.25 mm).
4. Basic switch shall be MIL-PRF-8805/4.
5. Lens holder can slide off when cap is removed from base. Each cap assembly shall accommodate a
film legend of .645 x .645 ± .010 x .004 ± .001 (16.38 x 16.38 ± 0.25 x 0.10 ± 0.03 mm) not supplied
(available legend area .600 square).
6. Cap assemblies shall be held captive to base assemblies by retaining element to prevent accidental
interchange.
7. Lamp terminals shall be permanently identified as shown. Switch terminals shall be identified as "C",
"NC", and "NO".
FIGURE 1. Design and construction - Continued.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business